LED upgrades for landscape lighting in Cullman and Morgan Counties, on the wire you already own
Your yard lights still come on, they just drink power and keep burning out. An LED upgrade puts new lamps or new heads on the cable already buried in your beds.
- Free estimates
- Licensed and insured
- Twenty years at outdoor work
- Family owned, based in Falkville
What actually changes when yard lights go LED
Most low voltage lighting in the ground around here was built for halogen lamps. A halogen bulb makes light by getting a wire filament white hot, which is why it draws twenty or thirty watts to throw a modest pool of light, runs hot enough to cook the socket, and gives up after a season or two of damp. An LED lamp in the same fitting makes similar light off a few watts and does not get hot enough to matter.
The low wattage is what opens the job up. A transformer that could only carry six or eight halogen fittings will carry a much longer run of LED heads, so the system you already have in the ground can usually grow instead of being torn out. Same trench, same cable, same box on the wall, more light where you want it.
The other half of an upgrade is deciding how the light should look, because LED lets you choose. Lamps come in warm tones close to the old halogen glow and in cold white tones that read blue against brick and pine bark. They also come in different beam spreads, so a lamp meant to wash a wall and a lamp meant to pick out one trunk are different parts, not the same part turned down.
How an LED lighting upgrade goes on your place
Start with a free estimate for your LED upgrade.
- 01
Tell us what is out there
Your town, roughly how many fittings, and whether they all still light up. If you know who put the system in or what brand is on the transformer, say so, because it decides how easy the parts are to match.
- 02
The system gets tested
Fittings get opened, the transformer gets checked against the load on it, and the cable gets looked at where it comes out of the ground. Corroded connectors and a dead run of wire show up quickly once somebody is actually testing.
- 03
Lamps, heads or both
Some systems only need the lamps changed. Some have fittings so far gone that a new head is cheaper than nursing the old one. You get told which parts of your system are worth keeping before anything is ordered.
- 04
Lamps in and heads aimed
New lamps go in, the load is checked against the transformer again, and each head is aimed at what it is meant to light. Glare pointing into a window or across a driveway gets corrected while we are standing there.
Signs your landscape lighting is ready for LED
Any one of these is reason enough to price an upgrade rather than buy another box of bulbs.
- You are replacing bulbs every few months and keeping spares in the garage.
- Half the run is dark and the fittings nearest the transformer are the bright ones.
- The lenses have gone cloudy and yellow, so the light is dimmer than the lamp inside it.
- You wanted to add more lights and were told the transformer was already full.
- The fittings get too hot to touch and the sockets inside them are scorched brown.
- Your power bill climbs in winter, when the lights are on for fourteen hours a night.
- Some lights read warm and yellow and the ones you replaced last read cold and blue.
That last one catches people out. Bulbs bought a few at a time over several years end up in different colour temperatures, and the eye notices mismatched light long before it notices a fixture. Doing a whole run at once fixes it, and because LED leaves spare capacity on the transformer, it is also the point at which adding to the system stops being a problem. Where the old fittings are too far gone to relamp, a fresh landscape lighting installation is the better answer than new bulbs in cracked heads.
Who comes out to change your lighting over
Black Diamond Outdoor Solutions is family owned and locally owned, works out of Falkville and covering surrounding areas, is licensed and insured, and has been at outdoor work for twenty years. Outdoor lighting is on the list of work we take on, LED upgrades included, alongside the grass, the stumps and the dirt.
That is worth something on an upgrade, because low voltage cable is buried in beds and under turf, and the ground it sits in is ground we work in. If the layout needs rethinking rather than relamping, that is the wider landscape lighting design conversation, and we will say so instead of selling you lamps that cannot fix it. Estimates are free.
LED lighting work we take on around Cullman and Morgan Counties
We cover Cullman, Falkville, Hartselle, Good Hope, West Point, Vinemont and Priceville. Lots here tend to be long and open, with the drive, the beds and the back line all wanting light, and that is the kind of layout an old halogen transformer runs out of headroom on first. Walkway runs tend to be the oldest part of a system and the first to fail, because the fittings sit low where water collects and where a mower deck passes within inches of them. Tell us the town and how many fittings you have.
What people ask before changing yard lights to LED
Can you reuse the wire that is already in the ground?
Usually, and it is the main reason an upgrade beats a fresh install. Direct burial cable in good condition does not care what lamp is on the end of it. What fails is the connectors, especially the pierce type that got crimped on wet and then corroded. Those get cut out and redone where we find them.
Do I need a new transformer as well?
Often not. LED pulls so much less that an existing transformer is normally oversized once the lamps change, which is the opposite of the usual problem. It gets replaced when the unit itself has failed, when the timer or photocell inside it no longer works, or when you want zones it was never built to handle.
Will the yard look different afterwards?
It will look cleaner and more even, and it will look the same colour everywhere, which an old mixed system rarely does. If you liked the warm halogen glow, say so and warm lamps go in. If you want the house to read crisper, a cooler lamp does that. The choice is made before anything is ordered.
Can you just change the bulbs and leave the fixtures?
Sometimes. Retrofit lamps exist for most common fittings and that is the cheapest route when the housings are sound. Brass and copper housings often outlive two sets of lamps. Thin aluminium and plastic ones usually do not, and we will tell you which yours are rather than fitting a good lamp into a cracked head.
Can I get a free estimate for an LED upgrade?
Yes. Free estimates are available. Judging a lighting system means opening fittings, checking the transformer against what is on the line and looking at the cable where it surfaces, so it is work done standing on the property rather than guessed at over the phone. We answer Monday to Friday, 8am to 5pm.
Tell us your town and roughly how many fittings are out there to request a free estimate.